BMW 5 Series: Engine Mechanical
BMW 5 Series G30 2016-2026 Training Manual / B58TU Engine / Engine Mechanical
READ NEXT:
Cylinder head
The following figures show the two cylinder head variants with and without
the cylinder
head-integrated exhaust manifold.
Cylinder head of B58TU engine
Cylinder head with integrated exhaust manifo
Crankcase
Honing process
Honing process "old/new"
Previous manufacturing process of internal cylindrical honing
New manufacturing process of form honing
The cylindrical bore hole of a combustion engine bec
SEE MORE:
Start/Stop button
Concept
Pressing the Start/Stop button
switches drive-ready state on or off.
Steptronic transmission: the
drive-ready state is switched on
when you depress the brake pedal while pressing
the Start/Stop button.
Pressing the Start/Stop button again switches
drive-ready state back off and standby st
Power supply terminals
Control units in the vehicle must be supplied with power only when they are
needed. The following
terminals are used in the G30:
Terminal 15N
Terminal 30B
Terminal 30F
Terminal 30
Terminal 15N supplies control units which are needed only when driving and
which may be needed to
safely end a j
© 2019-2026 Copyright www.bmw5g30.com
