BMW 5 Series: Concept, General information, Safety information
Concept
The lane departure warning alerts when the vehicle on roads with lane markings is about to leave the lane.
General information
This camera-based system warns starting at a minimum speed.
The minimum speed is country-specific and is displayed in the menu for the intelligent Safety systems.
Warnings are issued by means of a steering wheel vibration. The severity of the steering wheel vibration can be adjusted.
The time of the warning may vary depending on the current driving situation.
The system does not provide a warning if the turn signal is set before leaving the lane.
Vehicles with side collision mitigation: if in the speed range up to 130 mph/210 km/h a lane marking is crossed, the system intervenes with a brief active steering intervention in addition to vibrating.
The system thus helps keep the vehicle in the lane.
Safety information
Warning
The system cannot serve as a substitute for the driver's personal judgment in assessing road and traffic safety. There is a risk of accident.
Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.
Do not jerk the steering wheel in response to a warning.
Warning
Indicators and warnings cannot serve as a substitute for the driver's personal judgment. Due to its limits, the system may not issue warnings or reactions, or these may be issued late or in a manner that is not consistent with their normal use. There is a risk of accident. Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.
Functional requirements
The camera must detect the lane markings for the lane departure warning to be active.
READ NEXT:
Overview
Button in the vehicle
Intelligent Safety
Camera
The camera is installed near the interior mirror.
Keep the windshield in front of the interior mirror
clean and clear.
Switching on/off
Switching on
Warning function
If you leave the lane
If you leave the lane and if a lane marking has
been detected, the steering wheel vibrates in accordance
with the steering wheel vibration setting.
If the turn signal is switche
SEE MORE:
System monitoring functions
The Advanced Crash Safety Module has the following system monitoring
functions:
System self-test (pre-drive check)
Display of system operability
Cyclic monitoring
Fault display and fault storage
Output of faults (diagnosis)
Acoustic and visual seat belt warning
Deactivation of the front pas
Chain track
Comparison between chain track of B58 engine and B58TU engine
Chain track, two-part timing chain drive B58 engine
Chain track, single-part timing chain drive B58TU engine
6-cylinder engine
Upper timing chain
Timing chain
Lower timing chain
Drive chain, oil vacuum pump
The way the combin
